锂离子电池用聚合物电解质的最新进展II.含液聚合物电解质

由于干态聚合物电解质目前还不能满足聚合物锂离子电池的应用要求,人们致力于开发含液体增塑剂的聚合物电解质,包括凝胶型和微孔型两类体系。本文综述了含液聚合物电解质的最新进展,重点论述了各种新体系和新方法。     

熔融碳酸盐燃料电池阴极材料的导电性

通过交流阻抗方法研究了熔融碳酸盐燃料电池阴极材料锂镍氧化物、锂钴氧化物和锂铁氧化物的导电性能。结果表明:锂镍氧化物电极的导电性最好,锂钴氧化物电极的导电性次之,锂铁氧化物电极的导电性最差;它们的导电性都随着温度的升高而按指数规律增加;在合成锂钴氧化物(或锂铁氧化物)的过程中,使Li2CO3轻微过量,可以提高锂钴氧化物(或锂铁氧化物)电极的导电性,而且在同一温度下,随着nLi∶nCo(或nLi∶nFe,摩尔比)值的增大,锂钴氧化物(或锂铁氧化物)电极的导电性显著增加。     

添加剂对尖晶石型锰酸锂性质表征的影响

以LiOH·H_20和MnO_2为原料,分别掺入H_2BO_3、Al_2O_3、SiO_2和P_2O_5等添加剂,用固相分段法制备尖晶石型锰酸锂。结果表明,SiO_2和P_2O_5可以有效地改善LiMn_2O_4的电化学性能,H_3BO_3对锰酸锂的电化学性能影响不大,而Al_2O_3破坏了LiMn_2O_4的电化学性能。面扫描结果显示,Si或P元素各自都均匀地分散于LiMn_2O_4的物相中。从元素电负性和原子半径的角度分析了B、Si、P和Al元素对尖晶石型LiMn_2O_4结构和性能的影响。     

锂离子电池正极材料锂锰氧化物的固相合成研究进展

阐述了固相合成反应的原理，综述了锂锰氧化物的几种固相合成方法，并着重介绍了熔融渍法，多步加热法，机械化学法和微波化学法等在锂锰氧化物合成中的研究进展。     

Conceptual design of a high-efficiency absorption cooling cycle

The search for high-efficiency, gas-fired cooling cycles has led to the development of dual-loop absorption machines with cooling coefficients of performance (COPs) in the 1.2 to 1.7 range. This increased performance may call for high generator temperatures, new working fluids or new materials of construction. In most cases, two different sets of working fluids are required. The conceptual design presented here is aimed at obtaining high efficiencies with relatively low temperatures, employing only one set of fluids. The concept consists of two loops coupled in a configuration aimed at minimizing the loss of thermodynamic availability incurred when transferring refrigerant between the loops. The working fluid pair is a solution of lithium bromide-water. The calculated COPs are of the order of 1.8. The cycle relies on an elaborate evaporator-absorber combination. The paper presents the conceptual design, the critical assumptions, and the performance calculations for the concept.     

In-chain functionalization by alternating anionic copolymerization of styrene and 1-(4-dimethylaminophenyl)-1-phenylethylene

Anionic copolymerizations of styrene (M₁) with excess 1-(4-dimethyl-aminophenyl)-1-phenylethylene (M₂) were conducted in benzene at 25°C for 24h, using sec-butyllithium as initiator. Narrow molecular weight distribution copolymers with M?;_n = 16.1 × 10³ g/mol (M?_w/M?_n = 1.04) and 38.2 × 10³g/mol (M?_w/M?_n = 1.05), and 24 and 38 moles of M₂ per macromolecule, respectively, were characterized by size exclusion chromatography, ¹H NMR spectroscopy and DSC. The monomer reactivity ratio, r₁ = 5.6, was obtained from the copolymer composition at complete consumption of M₁, assuming that the rate constant k₂₂ =0,i.e. r₂ =0. The polymers exhibited T_g values of 128 and 119°C, respectively, which correspond to an estimated T_g = 217°C for the hypothetical homopolymer of M₂.     

Design for a high power-density Astron reactor

A liquid lithium blanket surrounding the plasma volume is described. The liquid lithium flows along magnetic flux tubes at a high speed. There is no vacuum wall between the blanket and the plasma. The E-layer of relativistic particles within which the plasma is confined serves as a vacuum wall protecting the plasma from the lithium vapor, which is continuously produced at the surface of the blanket, by ionizing the lithium atoms and ejecting the same along open magnetic lines. The heat load at the surface of the blanket generated by 14 MeV neutrons can be several hundred MW per square meter.Work performed under the auspices of the U.S. Atomic Energy Commission.Deceased September 24, 1972.     

Electron-Impact Cross Sections for Dipole- and Spin-Allowed Excitations of Hydrogen,Helium, and Lithium

Electron-impact excitation cross sections are presented for the dipole- and spin allowed transitions from the ground states to the np ²P states for hydrogen and lithium, and to the 1snp ¹P states for helium, n = 2 through 10. Two scaling formulas developed earlier by Kim [Phys. Rev. A 64, 032713 (2001)] for plane-wave Born cross sections are used. The scaled Born cross sections are in excellent agreement with available theoretical and experimental data.     

硼酸使掺铁铝酸锂发光增强的现象

在硼酸存在下合成了掺铁铝酸锂荧光体,研究了在不同温度下硼酸加入量对荧光体发光强度的影响,并通过X射线粉末衍射和粒度分析,初步探讨了发光增加的原因。     

The thermodynamic performance of a new solution cycle in double absorption heat transformer using water/lithium bromide as the working fluids

In this paper, a new solution cycle in the double absorption heat transformer is presented and the thermodynamic performance of this new cycle is simulated based on the thermodynamic properties of aqueous solution of lithium bromide. The results show that this new cycle is superior to the cycle being studied by some researchers. This new solution cycle has a wider range of operation in which the system maintains the high value of COP and has larger temperature lifts and operation stability. The relationship between the absorber and the absorbing evaporator is more independent and this makes the operation and control of the system more easier.